帶鎖鈕子開關
?有各種段數可選擇
?把手和端子有多樣化的選擇.
?端子點膠預防在焊鍚時的汙染物
?應用范圍：電信,儀器,測試設備,醫療設備.
多檔位鈕子開關產品圖片展示：
1YCM系列鈕子開關規格:
功率：取決于觸點材料.【5A@120VAC和28VDC 2A@250VAC Z大0.4VA@Z高20VAC/DC】
CONTACT RATING: Dependent upon contact material See page 11.
機械壽命：40000次操作以上.
MECHANICAL LIFE: 40,000 make-and-break cycles.
接觸電阻：在2-4VDC,100mA時，鍍銀和鍍金點的Z大電阻為10毫歐.
CONTACT RESISTANCE: 10m?max. initial @ 2-4VDC,100mA for both silver and gold plated contacts.
絕緣電阻：Z小1000兆歐.
INSULATION RESISTANCE: 1,000 M??min.
絕緣強度：觸點間Z低1000VAC至少1分鐘，在觸點與外殼之間Z低1000VAC至少一分鐘.
DIELECTRIC STRENGTH: 1,000 Vrms min.@sea level.
工作溫度范圍：-30°C到85°C.
OPERATING TEMPERATURE: -30°C to 85°C.
材質：
MATERIALS
外殼：苯二酸二烯丙酯樹脂（UL94V-0)
CASE: Diallyl phthalate (DAP) (UL94v-0).
搖桿：黃銅鍍鉻.
ACTUATOR: Brass,chrome plated.
銅頭：黃銅鍍鎳.
BUSHING: Brass, nickel plated.
框架：不銹鋼.
HOUSING: Stainless steel.
支撐支架：銅鍍錫.
SWITCH SUPPORT: Brass, tin plated.
CONTACT / TERMINALS: Brass, Silver or gold plated.
彈片&端子：鍍金或鍍銀.
焊錫條件
手工焊：用烙鐵30瓦，控制在350℃，約5秒，同時應用焊料.
MANUAL SOLDERING: Use soldering iron of 30 watts, controlled at 350℃，approximately 5 seconds while applying solder.
波峰焊：推薦焊接溫度：260±5℃
WAVE SOLDERING: Recommended Soldering Temperature: 260±5℃
錫侵泡時間：Z多5秒.(PCB板的厚度為1.6mm)
Duration of Solder Immersion: Max 5 sec. (PCB is 1.6mm in thickness)
焊接：波峰爐
撥動開關,搖頭開關,鈕子開關,防水鈕子開關,防水搖頭開關,2檔搖頭開關,雙回路搖頭開關,,,
企業產品目錄展示：
